[Zanny4]

Good Morning / Afternoon Gents

I have a 4030 trumpf laser and we have been asked to spec a job for Cutting and Etching Corian, We have no clue on where to start with the cutting condtions, The material is aluminium based but cant find anything on the cutting side of it. The laser is about 10yrs old now and cuts well for its age. Just wondering if any of you guys out there have cut this material before and how you found out the cutting condtion, Was it a mess around and hit and miss or is there a specif condtion for this material. Any help would be greatlly helpful

Thanks in advance

Zanny ^^

[KevinWilkins]

This is the wrong forum for this question.


wilkins-knives.com
facebook.com/wilkins.knives
[email protected]

[Ken_Shea]

Hi Zanny,
My apologies, you did not get a very warm welcome here nor any help.

Try here and you should be able to get some needed help.
http://www.cnczone.com/forums/genera...ne-discussion/