Hi there, I am looking to firstly buy a house in Adelaide and looking to build a shed and install a CNC lathe and VMC. Probably not looking at anything too big but something to make some parts I am currently doing afterhours at work. I have contacted the power company over here and they were concerned about peak loads on CNC's. The lathe I am looking at would probably have a peak startup load of about 60 amps, the mills would probably be less so with a small mill running would this be likely to trip out my board? I have heard of soft starters but know nothing about them, just curious if anyone has had any luck running a small shop from a 63 amp supply? Thanks for any help, Jimmy