I went to you'r site and will say you have some very nice machines. What I have is a table top engraver that I'm attempting to get up and running. Been a machinist for 30+ years and I'm thinking that's probably getting in the way more than it helps. I'm new to generating code using software, but I have managed to get Master Cam to generate a program for my project. I verified the tool path's in Master Cam, but the software I'm using for controls (Kelly Cam) won't run it. I"m wondering if I'm using the correct post processor.:drowning:
Results 1 to 2 of 2
-
07-28-2015, 07:44 PM #1
Registered
- Join Date
- May 2015
- Posts
- 3
Am I using the correct post processor?
-
07-29-2015, 07:16 PM #2
Registered
- Join Date
- Aug 2006
- Posts
- 671
Re: Am I using the correct post processor?
I'm not familiar with kelly cam, but there is a good chance that your post will need tweaking before it'll run perfectly. I know Mach3 has it's quirks that I've had to work around.
Will it not run at all or does it stop mid code?
Reply With QuoteSimilar Threads
-
This may not be the correct sub-forum for this post, but - - - -
By Joe T in forum Community Club HouseReplies: 8Last Post: 08-15-2013, 06:06 PM -
Correct SprutCam Haas Post for TM-1
By mecheng10 in forum SprutCAMReplies: 1Last Post: 03-28-2011, 07:50 PM -
Anyone have correct post for Mastercam 8 to fadal vmc 88hs
By wiley125 in forum FadalReplies: 0Last Post: 03-31-2010, 03:04 PM -
What's the correct post processor code for EMC2?
By OneAndy in forum Uncategorised CAM DiscussionReplies: 2Last Post: 10-19-2008, 03:05 AM -
Looking for the correct post processor
By twooten in forum Post Processor FilesReplies: 0Last Post: 01-22-2008, 09:55 PM
Tags for this Thread
Posting Permissions
