586,055 active members*
4,068 visitors online*
Register for free
Login

Thread: Fanuc robocut alpha-OiE

Results 1 to 3 of 3
  1. 08-10-2015, 04:01 PM #1
    pife82
    pife82 is offline Registered
    Join Date
    Aug 2015
    Posts
    2

    Question Fanuc robocut alpha-OiE

    Hi.
    I'm looking for help to give reference to the axes of the machine, I can not find the parameter screen, there is a password to do this?
    regards...
    excuse my bad English ..
    Reply With Quote Reply With Quote
  2. 08-13-2015, 07:32 AM #2
    theblackwatch
    theblackwatch is offline Registered
    Join Date
    Nov 2011
    Posts
    13

    Re: Fanuc robocut alpha-OiE

    Hi pife82
    please check maintenance manual , I. installing the machine, Ch 2 Setting & Adjustment
    Have lost all Axis ref points or just some?
    If lost all you will have to set your water level as well as there is a servo driven motor for the drain on the working Tank.
    Good luck
    TBW
    Reply With Quote Reply With Quote
  3. 08-15-2015, 06:22 PM #3
    pife82
    pife82 is offline Registered
    Join Date
    Aug 2015
    Posts
    2

    Re: Fanuc robocut alpha-OiE

    Hi theblackwatch:
    I did not have the maintenance manual,but already I have, as you say actually there is information which required...
    thank you very much for your help ..

    regards...
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. EDM Cutting Conditions For FANUC Robocut (alpha)-OC and (alpha)-OiA
    By aaronell in forum EDM Discussion General Topics
    Replies: 2
    Last Post: 11-02-2015, 07:01 PM
  2. Fanuc Robocut alpha-OiA 18i - W series FOCAS
    By dave_the_bear in forum Fanuc
    Replies: 2
    Last Post: 09-11-2012, 09:37 PM
  3. Fanuc ROBOCUT Alpha-1B will not power on the control
    By TRG in forum EDM Discussion General Topics
    Replies: 1
    Last Post: 07-04-2011, 09:51 PM
  4. Post processor for Fanuc Robocut alpha-oiE needed
    By andy62 in forum EDM Discussion General Topics
    Replies: 0
    Last Post: 04-29-2011, 01:26 AM
  5. Help needed with FANUC Robocut Alpha-OiA and the controller is a series 18i-W.
    By mrbernardjhahn in forum Fanuc
    Replies: 2
    Last Post: 01-14-2011, 08:51 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules