Greetings,

I am not using any of the I/O on the Kflop or the KStep, but only want to use the Konnect Board for Input and Output.

However, something about the Konnect board and its interface, is interrupting the Jog ability of the X axis or CH0... If I disable the output 35, which stops the boards communications, jogging is allowed again...

Note: This problem also translates to the KMotionCNC as well.
_____________________

Do you have any clue as to what this confict is? I am using Ver. 4.32.

This is the second bug, including the previous GetVirtualBits(??) problem.

Sincerely,

Jeff