Hello!
My name is Alex, I am a newbie from Tustin, California. I just recently purchased this VMC from a private seller. The machine is currently stuck on Servo Alarm : 11 (X Axis) 21 (Y Axis) 31 (Z Axis) machine not ready.
There are no alarm displayed on the tool number, No light on Green Power light for the operator control panel. In the left power cabin; Servo Amp. Board has "VCC RDY" led on all 3 axis boards, No light on P RDY on all three. Power input on #3 #4 wire measured @ ~110V for servos. Please give me some suggestion where I should start checking.... The machine wouldn't move at all.

Note: The parameter was accidentally lost during the power supply repair..... copied the parameter from a 1988 model mycenter1/ fanuc 3m w/ drip feed upgrade....so I am pretty sure one or more lines are incorrect on my machine's parameter list...

please, any help would be appreciated! thank you for your time!


- Alex