[alexeye169]

Hello!
My name is Alex, I am a newbie from Tustin, California. I just recently purchased this VMC from a private seller. The machine is currently stuck on Servo Alarm : 11 (X Axis) 21 (Y Axis) 31 (Z Axis) machine not ready.
There are no alarm displayed on the tool number, No light on Green Power light for the operator control panel. In the left power cabin; Servo Amp. Board has "VCC RDY" led on all 3 axis boards, No light on P RDY on all three. Power input on #3 #4 wire measured @ ~110V for servos. Please give me some suggestion where I should start checking.... The machine wouldn't move at all.

Note: The parameter was accidentally lost during the power supply repair..... copied the parameter from a 1988 model mycenter1/ fanuc 3m w/ drip feed upgrade....so I am pretty sure one or more lines are incorrect on my machine's parameter list...

please, any help would be appreciated! thank you for your time!


- Alex

[engravo]

Furqan Ahmed
Also i have fanuc 3m model C .My machine is running condition at this.But My machine memory is too shot only 8kb Please you advice me what is the Procedure apply to upgrade my machine in DNC with
3Axise at a time move.
Thank You.
My Email: [email protected]