586,117 active members*
3,301 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Leadshine > MX3660 Touch Plate Question

Thread: MX3660 Touch Plate Question

Results 1 to 2 of 2
  1. 08-28-2015, 12:04 AM #1
    Donny M. Carter
    Donny M. Carter is offline Registered
    Join Date
    Jun 2012
    Posts
    36

    MX3660 Touch Plate Question

    I have the MX3660 and I'm trying to figure out where to connect the probe and ground wire. I see in Mach where I need to make the correct settings, but not sure about the actual hookup. Thanks in advance for any help or info!

    Donny
    Reply With Quote Reply With Quote
  2. 09-01-2015, 09:15 AM #2
    Leadshine
    Leadshine is offline Registered
    Join Date
    May 2015
    Posts
    38

    Re: MX3660 Touch Plate Question

    Hi Donny
    I have replied your email .


    John
    Application engineer
    Leadshine
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. mx3660 question
    By basselete in forum Automation Technology Products
    Replies: 0
    Last Post: 09-29-2014, 01:20 AM
  2. CNC Touch Off Plate
    By bgriggs in forum DIY CNC Router Table Machines
    Replies: 6
    Last Post: 01-04-2014, 05:48 AM
  3. z touch off plate
    By Alwaysintheknow in forum Chinese Machines
    Replies: 1
    Last Post: 06-10-2013, 03:20 AM
  4. NO Touch Plate and NC Touch Probe switch inversion using an Arduino UNO
    By Kenny Duval in forum Benchtop Machines
    Replies: 12
    Last Post: 06-05-2013, 06:05 PM
  5. Touch off plate
    By rich_cree in forum Benchtop Machines
    Replies: 2
    Last Post: 06-03-2010, 06:05 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules