Hello!

I have an Electro-Craft BRU-200 brushless servo drive.

http://www.ab.com/motion/ec/0013-1028-001-B.pdf

Basically, I would like to know if I'll be able to use this drive at home with a PC and not have to buy anything too expensive to get it working. It was cheap and I have a matching motor for it - it would be nice to get them running if possible.

The pin information is on pages 24 and 25 of the pdf.

I'm thinking that it does not take step and direction commands, right?

Any help would be greatly appreciated!
Thanks!