I am in need of a face milling macro to true up the tombstone in my HMC. It is a fairly old Kitamura Hx 400 and the B axis had went bad. And to correct it the tombstone had been milled to compensate. We just got done fixing the issue with the B axis so now the tombstone look like the top was just twisted and pulled up. :drowning:
Ideally i would want start at lower corner move over in X, retract Z, go back to Original X, increment up in Y, back in Z at depth and so on. Only macros i have been able to find start at center and incrementally go out from center.