Quote Originally Posted by tbev View Post
Did you ever figure this out?
The first three fonts I tried didn't work, at all. I rebooted the controller and tried again. Still didn't work. Later on, I came back to it and tried again at a much larger size (0.22" if I recall) and all of a sudden they worked. The first 3 fonts I tried didn't render in the GUI like the fonts do and they wouldn't post (no error message) My guess (and only a guess) was that I was trying to do them too small OR maybe the particular letters I chose the second time didn't have problems and the first time they did.

So, with that being said, Your mileage may vary. Next time I get back in the garage I'm going to try engraving font test pieces again with a new tool and I'll play around again and see if I can tease out what exactly caused the "no error / no file save dialog" condition.

Go ahead and try TTF files, just be prepared to play with it a bit. It really could have been my inexperience, possibly.