586,106 active members*
3,239 visitors online*
Register for free
Login

Thread: Work holding

Results 1 to 3 of 3
  1. 12-02-2006, 09:21 AM #1
    reachraghu
    reachraghu is offline Registered
    Join Date
    Nov 2006
    Posts
    18

    Lightbulb Work holding

    Hi,

    We are working on a new project, where we have to turn (Hard turn) a component which is about 270mm long, 25.4 dia, (component is with centers). Here at one end there is a spline. The requirement is the other end dia (about 17.0) should be out within 20 microns with respect to the nominal dia of spline.

    Can you give some suggestions?

    Thanks for any help.
    Reply With Quote Reply With Quote
  2. 12-09-2006, 05:56 PM #2
    widgitmaster
    widgitmaster is offline Member
    Join Date
    Jun 2005
    Posts
    3502
    Providing you have a very close fitting mate to the spline, you may be able to fixture that end at the spindle and as the drive!

    No, that wont work either!
    Just a thought!
    Eric
    Reply With Quote Reply With Quote
  3. 12-11-2006, 01:24 PM #3
    reachraghu
    reachraghu is offline Registered
    Join Date
    Nov 2006
    Posts
    18
    Also thinking of a collet chuck. The collet having its Int. Dia as the spline.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules