Hello everyone,
I'm new to this forum. Don't know exactly how this all works but hope for the best.
Recently the machine I work with (AMADA Vipros 2510 King) has popped up SYSTEM ERROR; 914 SRAM PARITY: (2N) ... and lots of hex bit addresses in description. I was advised by unofficial specialists that the software chip might be broken but sometimes it just helps to do a reset (holding RESET and DELETE buttons, well it's figured out). The problem is that after reset I would need to enter machine parameters, PMC parameters, alignments, tolerances etc. and I do not have any back-up of those parameters in any form. Maybe someone could help me with files or text of the needed parameters after the reset procedure? I'd be much appreciative.
Controller module is FANUC 18-P
Please PM
Thanks in advance