im not sure how to upload a program from r232
witch mode I have to be in?
then what do I do to read the r232 input
is the mode selector to be on the rs232c or edit?
im not sure how to upload a program from r232
witch mode I have to be in?
then what do I do to read the r232 input
is the mode selector to be on the rs232c or edit?
MDI
got it, I had t be in edit, then (softkey)prog. then type in O0003 then (soft key) IN
Now how do I change the controller to metric?
manual says its perm.#6636-6638. What value do I enter?
Yaskawa has been kind enough to post all of the manuals for all of their products on their website. They can be downloaded free of charge, you don't even have to register to get them. Here is a link to all of the MX3 manuals https://www.yaskawa.com/pycprd/downl...r%20Guides/all Hope this helps.
To change from inch to metric, or metric to inch, change 6001 bit 0