[Vindiboy]

I am looking help with wiring a ASHE FX1500 spindle controller, It controls a SEM 130v motor and I am trying to avoid changing it as there could be problems with mounting on mill etc.
I would have liked to control the motor via MACH3 but running it manually would do for now.
I believe all I have to do is connect a 30K potentiometer across pins 1,2 & 3. I would like to know
if this is right. Pin 3 has 12v on it.
Jim

[edmo117]

JIm

Did you ever sort this out?

I have just acquired a Connect CNC Mill with an ASHE FX1500 spindle controller and was wondering if you knew what pins were what on the board. I can leave it connected to the spindle motor as is but need to feed into it the speed control signal and wondered if you know what that has to be. i.e. PWM or 0-10v. Any help would be much appreciated.

Cheers

Brian

[malutki669]

Hello Brian......do you have any information about Ashe fx 1500. I can not find anything on the web. Regards Paul

[barkerp187]

I have just purchased a Conect Contour Mill and it has been fitted with a Leafboy77 control card and a ASHE Controls FX1500 spindle controller. My computer is running Mach3 and I can control the three axis but I cannot work out how to control the spindle by MACH3 via the PWM control. Is there anyone out there that can help me.

Paul