[camivic]

Hi guys,
i've problems to find the correct configuration and wiring for the classic limit switch.
I don't understand which function is need to set in "INPUT TRIGGER" window to stop an axe when the limit switch is pressed.
Someone ca suggest me the right way?

Thanks to all.

Vincenzo

[vmax549]

Go to teh config screen then select the axis you are working with. You willl see a setup box for limit+ ,Limit - . Input the values for the Pin and Port of the UC300 that you are going to use . Then select either active high or low to match your switch arrangement . Apply and Save the settings and you should be good to go.

(;-) TP

[camivic]

I'm very stupid!!!!!
I don't know because i've searching in the "INPUT TRIGGER" windows!!!!
Many thanks.