Hello
I need to mill a 5.5mm dia hole x 7.5mm deep in the face of a part.
Using Doosan fanuc Oi
The hole centre is 4mm from the centre of the part (X0)
Assuming a 4mm hole is already drilled.
I've had a go, would be grateful if you guys could have a look & le me know what you think:
N07 (AXIAL MILLING)
(HOLE DIA: 5.5)
(HOLE CENTRE POS: 4.0MM FROM CENTRE OF PART)
G0G17G40G80G97G98
G28U0V0
G28W0
M05P11
T0707(4MM END MILL)
M35
G28H0
G50C0
M89
Z5.S2000M3P12
G54X0.Y0M8
G1Z1.F200
G41X13.5(HOLE DIA POS. (4X2)+5.5))
G02I-2.75W2.0(W=PITCH)
G02I-2.75W2.0
G02I-2.75W2.0
G02I-2.75W2.0
G02I-2.75W0.5
G02I-2.75W0.
G01X13.
G0Z5.
G00G40X0.
M90
M5P12
M34
G28U0V0M9
G28W0
M01