Hello,
I built a 3 axis machine the uses a slave drive on my x axis. Everything runs and works great other then homing.
When homing my x axis, everything is fine until the axis hits the limit switches. Once the switches are activated both the slave and master motors want to go the the opposite direction.
I have a normally open proximity switch on my slave side and a normally closed on my master side.
I have tried changing both my Active Low settings and Home Neg settings.
The only thing i can think is that maybe my Slave axis is wired backwards.< i am not sure if it is or not, but i do have my slave axis uncheck for Dir Low Active.
hope someone can help,
Thanks,
Mike
I