586,055 active members*
4,176 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Fanuc > Fanuc 0M KIA VA-40 Spindle Orient issue

Thread: Fanuc 0M KIA VA-40 Spindle Orient issue

Results 1 to 2 of 2
  1. 11-11-2015, 08:42 PM #1
    WICNC_85
    WICNC_85 is offline Junior Member
    Join Date
    Aug 2013
    Posts
    4

    Fanuc 0M KIA VA-40 Spindle Orient issue

    We have been having spindle orientation issues.

    The issue is during a tool change the spindle will orient but then the machine will sit there. Sometimes this happens......sometime the machine tool changes fine with no issues.

    I thought that the input from the spindle amplifier was faulty but found the input in the ladder and all is fine there. So I kept searching to see what was hanging up. I found that F150.0 is not resetting all of the time after the spindle orientation is complete. I'm assuming that this is the m code for spindle orientation? the manual that I have does not give much info other then the saying "m-code". Is this possible and if so what can this?

    Thanks for anyhelp
    Reply With Quote Reply With Quote
  2. 11-11-2015, 08:49 PM #2
    ifixcnc
    ifixcnc is offline Registered
    Send a message via Yahoo to ifixcnc
    Join Date
    Jun 2004
    Posts
    511

    Re: Fanuc 0M KIA VA-40 Spindle Orient issue

    F = Flag That is normally an internal thing. Call Fanuc, they will help you.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Conquest 42 Fanuc OT control, Spindle Orient
    By edeaton in forum Hardinge Lathes
    Replies: 8
    Last Post: 12-31-2015, 07:44 PM
  2. Spindle Orient Speed Fanuc 15MB
    By jdandersonjr in forum Fanuc
    Replies: 1
    Last Post: 04-10-2014, 04:37 PM
  3. spindle orient fanuc 15 series
    By tleck in forum Fanuc
    Replies: 6
    Last Post: 02-18-2011, 03:03 PM
  4. Fanuc 15M Spindle Orient Problem Please Help!
    By stang623 in forum Fanuc
    Replies: 2
    Last Post: 12-28-2008, 07:35 PM
  5. how do you orient spindle in program (fanuc 18m)
    By rubino2112 in forum Fanuc
    Replies: 2
    Last Post: 01-24-2007, 06:56 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules