[binzer]

We just got a new Haas 160 trunnion running it in a vf2 at every tool change the trunnion goes back to zero. Is there a parameter for this to keep it at 90 and not go back to zero? Thanks

[Machineit]

Post your code.

Mike

[binzer]

Don't really need the code let's say I put trunnion at 90 deg manually then do a tool change in MDI the trunnion will go back to zero or are you refuring to tool change code

[nmachine]

Anybody know this one?

[nicknackks]

Hit the PARAM/DGNOS key, type in 269 and then hit the down arrow. The fourth line down should read ZERO AXIS TC. If this is set to a 1, the axis will go to zero every time a tool change is commanded. If this is set to 1, change it to zero and let me know if that fixes the problem.Make sure you don't run the tool changer double arm into the trunnion when you leave it at 90 degrees.