535,704 active members*
3,835 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Fanuc > Fanuc Series 15-M Trouble uploading Ladder Program
Results 1 to 6 of 6
  1. #1
    Registered
    Join Date
    Oct 2006
    Posts
    9

    Fanuc Series 15-M Trouble uploading Ladder Program

    I have an old custom machine with a Fanuc Series 15-M PMC and 14 axis'. I need to do some modifications to the ladder program but I am currently unable to upload it from the PMC. I've tried FAPT Ladder I, II and III with no luck. I've also tried using a Handy File without any luck. Is it even possible to upload the ladder program using a pc? Or is this model too old?

    I would appreciate any advice or assistance.

    Thanks,

    Greg Elliott
    Controls Tech

  2. #2
    Registered
    Join Date
    Nov 2004
    Posts
    53
    Hi Greg,

    I write quite a few ladders but have never done one for a 15, however I have the manual for all Fanuc pmc's and will get all the information in the morning.

    If you still need it then, maybe someone will have the answer before.

    I cant remember if the 15 pmc was in eprom or not if so thats a problem.

    Regards

  3. #3
    Registered
    Join Date
    Nov 2004
    Posts
    53
    Hey Greg,

    I will be out on service until tomorrow finishing up a retrofit, I will scan the pages you need and get them to you on Saturday.

    Thats about the best I can do.

    Regards

  4. #4
    Registered
    Join Date
    Oct 2006
    Posts
    9
    Quote Originally Posted by debco99 View Post
    Hey Greg,

    I will be out on service until tomorrow finishing up a retrofit, I will scan the pages you need and get them to you on Saturday.

    Thats about the best I can do.

    Regards
    Sounds good to me debco99. Whenever you get a chance that would be great!

    Thanks,

    Greg

  5. #5
    Registered
    Join Date
    Nov 2004
    Posts
    53
    Greg, I have the information you need (pdf's) get in touch with me at
    sales@debcomachinery.com

    Regards

  6. #6
    Registered
    Join Date
    Dec 2007
    Posts
    2
    Hi I have a problem

    I need to open a pmc ladder RB2 but whit the version 3.4 and 4.2 is impossible

    can you help me?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •