Greetings from slovenia.
Im not very active on this forum or anny forum but i read alot on CNC zone.
I have a question i would also say i need an advice. My whole story is i bought an chinese CNC in december 2013. The next step was to build my own cnc machine.
And now in december 2015 i'm looking to buy an Mikron WF3DCM the price is around 7500€ good condition. The controller is TNC 155 Heidenhain. I found out that it loves to move with all 3 axis at the same time.
In the future i'm planning to change the controlling system and the motors.
Any advice and suggestions will be greatly appreciated
Regards
Rok