Hello everyone,
Does anyone know the Techno CNC LC Series 4896?
Last September, I bought a used techno CNC and I had no experience.
After 3 months of learning and use, a problem occurred: PositionErrors, No Power Controller...
I was told to replace a motor of $1500 on the Y axis and it still notworking well.
Curiously, it works well when very slowly "Turtle Mode" butwhen I increase speed I have this message:
"M1 position error (Y axis) No Power Controller".
Q: Have you ever had a similar problem?
Now the are telling me that the problem comes from the PCI card.
I have 80% chance that the card is repairable.
If not, I have to buy a new equipment because my PCI card isdiscontinued !!!
Q: Does anyone have a PCI card for sale for a Techno CNC 4896 LC SeriesPart No H20T43-PCI400 RoHS?
Thank you in advance for your help!
P.S. French Canadian, I hope you understand my English