small c error on master PCB after short circuit of 24 volt input switch power
I have a problem with a leadwell MCV 550 with a fanuc 10MA control. In order to repair this problem(or part of the problem), I need to know the proper value of a burnt out resistor on one of the circuit boards. The A20B-1000-0800 circuit board on the side of the CRT and also connected to the pulse encoder wheel has a connector CA3 above which are 2 light blue 1 watt resistors mounted horizontally. The one on the right side was burnt out and is Attachment 300886Attachment 300888 removed. Could someone please read the ohms value off that resistor RA10? The one beside it on the left is 1.0K. Above the leftside one of three blue connectors(CA3) is where we're looking.
FYI The machine was still working, but only if warmed up a long time in the small c error condition on master PCB.