So I just got my machine and I can't get it to cut but it will engrave. I am using RDWorks to send the job to the laser. I created a box, and then set the laser to 10mm/sec and 60% power. When I run the Job, it goes through the movement but the laser does not turn on. If I load a jpg and go to scan/engrave, the laser turns on and engraves.
Strange. Is it in the RDWORKS software or the software on the machine?
Brand: Vevor
Model: 750LEM
60W CO2 USB Laser Engraving Cutting Machine ENGRAVER Cutter Woodworking Crafts | eBay