[Erik D_lux]

Looking for a quote on 2 different parts. .002 +/- tolerance is fine.

First part, "locker"

I need these made from 4340. Looking for approx 150-200 parts.

Second part, "axle shaft"

I need these made from 4340 also. Looking for approx 300 total pieces.

This should be on going and hopefully need many orders of both after the initial order.

Please shoot me a price and ETA either in PM here or at [email protected]

If it helps, I think I can get step files and possibly many others of both files. If you need a specific file type, please let me know which works

Thanks and let me know if I missed anything.

[IndianCreekGary]

Erik, email sent for files, thanks for the opportunity.

[w.m.s.]

Can any tolerances be outside the +- .002?

[Erik D_lux]

Erik, email sent for files, thanks for the opportunity.

Thanks! I just sent an email back.

Can any tolerances be outside the +- .002?

Yeah. Are there specific ones youre concerned about?

[w.m.s.]

Some of the longer turned lengths and quite a few of dimensions in general. Hole diameters and some of the shorter od dims are no problem. An increase to +- .005 or .010 on many dimensions would make the part quite a bit easier to make. I would also consider that many here will send you parts not to +-.002 tolerance you are calling for. How about finish requirements? PM sent for additional info.