Re: How do you place material on table safely
I bolted a couple "standards" on the back side of my table. to help align plate parallel.. Carry plate in with fork lift I always leave apx 1' of plate extend beyond fork tips...... once carried over table lower & tip out till edge of plate makes contact with slats Then back out. Plate will slide down forks as you back out lowering second edge to the slats without any banging around. I Handle & place 4' X 12' A 1" A36 this way also 1 1/2" X 4' X 8' sheets.
If it works.....Don't fix it!