Hey guys,
I'm new to the CNC thing. I've been using mills and lathes for 4 years now and I've decided to get into CNC. I have done some researching on boards and I have a specific question. I've been looking at the Stepperworld FET-3 controller,
http://www.stepperworld.com/
It says the board is controlled via parallel port. Heres the problem The computer I have does not have a parallel port, it has a serial port! Would the FET-3 work with through the serial port if I used an adapter?
If not what might my options be for solving this problem?
Are there any different boards that might work?
Thanks alot,
Mike