We just purchased a daewoo 3016 vertical and cannot get programs from the memory card to the machine . We followed the instructions of the supplimental manual they supply .It is set to accept memory cards(variable set to 4) and not for rs 232. It reads the programs on the card (at the machine) ,it just wont allow us to load to machine . The worst part is our vendor is out of town till after the first of the year. Any tips or suggestions would be appreciated as we are anxious to get this machine cutting chips . I know the programs are valid because I run them on our Omc control with no problems.Just need to find what step/steps I am missing to start cutting. Thanks.