Hi guys-
Machine is a Robodrill Mate with a Oi-MC
I'm using a master tool (a Haimer) to set G54 and such in my machine, and I'm using it as my master tool.
1- I touch it off on my gauge block, go to Position > Relative Position and set Z0 as the origin.
2- I touch my tools off on that surface, and set their offsets with Input C in the Offsets page.
3- Everything works... UNTIL I turn the machine on/off again. The relative coordinates change...
So do I need to go grab my master tool and touch off *every single time* my relative position changes or the machine restarts?
Thanks!