The easiest way would be to get an IMS Mdrive plus, and program is to move 5 degrees from an input, connect the input to a switch, and there you have it.
http://www.imshome.com/mdrive23plus_mdi.html
I have been using them for the last 5 year and they are very good, and easy to set up.
If you want to use your exiting motor and driver, then gearing is most likely the best way.
Work on full step (+-5% of a full step accuracy) and use a belt & pulley or a low backlash gearbox.
Originally Posted by
Syphonics
my application requires me to slot a piece of abrasive paper at the interval of 5 degrees.
by doing a belt drive with a 20 and 36 teeth, it gives me 1 degree per steps and thus allows me to get 5 degrees.
but after long run will the belt drive still be as precised? or does gearing helps? which is more precised?
thank you
Motion Control Products Ltd
www.motioncontrolproducts.co.uk