Does anybody know how to disable/enable look ahead on OSP-P200?
Thanks
Does anybody know how to disable/enable look ahead on OSP-P200?
Thanks
Use single block
- look ahead cannot be bypassed when using cutter comp, as this is required to calculate compensated tool move positions relative to the programmed contour ( minimum look ahead is 4 lines of NC code )
Thanks. I am not using cutter comp. I need to do some calculation using variables (VC) and in auto mode (not single block) the calculation is done ahead of time. Immediately after I start the program the values of variables change to their final state..
Try this
VOPRB[2]=VOPRB[2] OR 128 (Sets NC Opt Para Bit No2. Bit7 to 1)
Code in here
VOPRB[2]=VOPRB[2] EOR 128 (Set NC Opt Para Bit No2. Bit7 to 0)
I think you can add 4 dummy blocks or use an M331 if I remember right. Don't have a book in front of me at the moment...depends on if it's a L or M though.
Best regards,
Great. It works. Thanks
hy bffelix, i know that this is 4yrs old, but what exactly where you after ? why did you needed to buff-prohibit some math ?
please, can you share your code ? kindly
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg