I think you steps per are OFF by a factor of 10. Perhaps your setting for Micorsteps on teh drive is NOT correct. I acts like it is set for 1 instead of 10.
(;-) TP
Results 1 to 5 of 5
Threaded View
-
02-20-2016, 03:52 PM #5
Member
- Join Date
- Oct 2005
- Posts
- 1145
Re: Mach3 4th Axis Indexer Jumps Step
Reply With QuoteSimilar Threads
-
Axis jumps 0.0002 after stopping
By Houndogforever in forum FadalReplies: 0Last Post: 01-10-2016, 07:33 PM -
X axis jumps out of alignment randomly
By FlyingThinkTank in forum Avid CNCReplies: 9Last Post: 09-17-2015, 02:39 AM -
Step Indexer From Digital Machinist magazine
By wtxrcdog in forum ArduinoReplies: 7Last Post: 04-15-2015, 04:56 PM -
Mach3 New Install MDI Screen Pressing X Jumps to DRO
By cjjonesarmory in forum Mach Software (ArtSoft software)Replies: 3Last Post: 12-21-2011, 06:31 PM -
Mach3 y axis dc servo jumps when moving small increments only.
By mif73 in forum Mach Software (ArtSoft software)Replies: 5Last Post: 09-15-2008, 09:32 AM
Tags for this Thread
Posting Permissions
