We just bought a used 2005 prodis pdc-1050 MIll with a Fanuc oi-mc control, worked perfect when we bought it but when we brought it to our shop and hooked up the power and turned it on suddenly we have every sensor alarming out and no power to the servos, we have checked the power everywhere we can and it all looks good. We are at a complete loss right now.
Results 1 to 2 of 2
-
03-11-2016, 07:29 PM #1
Registered
- Join Date
- Mar 2016
- Posts
- 2
Fanuc oi-mc not sending power to control
-
03-11-2016, 08:54 PM #2
Registered
- Join Date
- Jun 2004
- Posts
- 511
Re: Fanuc oi-mc not sending power to control
Your I/O has a problem. Look at the X bits on the diagnose page, if all are the same you have a 24 volt problem. The machine will not turn on the drives with that condition.
Reply With QuoteSimilar Threads
-
Fanuc 0 control power supply blown twice.
By Harmeet in forum FanucReplies: 15Last Post: 09-20-2015, 06:40 AM -
Fanuc ROBOCUT Alpha-1B will not power on the control
By TRG in forum EDM Discussion General TopicsReplies: 1Last Post: 07-04-2011, 09:51 PM -
Fanuc 10TF Control Power Issue
By rbleth51 in forum FanucReplies: 15Last Post: 08-20-2007, 08:22 PM -
Control Oi not receiving end not sending a program
By avaitsis in forum DNC Problems and SolutionsReplies: 1Last Post: 07-23-2007, 09:43 PM -
Sending a Command to Control
By daking in forum NCPlot G-Code editor / backplotterReplies: 1Last Post: 05-02-2006, 10:04 PM
Tags for this Thread
Posting Permissions
