I have a mach3 interface board ver 1.1 and bl -tb6560 v2.0 driver board. i need help on how to tire the the two together. i have looked all over an have not come across any diagram. any help would be apprenticed . hope i posted i the right section
I have a mach3 interface board ver 1.1 and bl -tb6560 v2.0 driver board. i need help on how to tire the the two together. i have looked all over an have not come across any diagram. any help would be apprenticed . hope i posted i the right section
Your motor drivers should have 2 power connections and 4 connections for step and direction. Either the + or - will be common and the other two will direct your step and direction. Your board and driver documentation should spell this out.