586,112 active members*
3,075 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Benchtop Machines > Angular Bearings in a RF 45

Thread: Angular Bearings in a RF 45

Results 1 to 2 of 2
  1. 01-13-2007, 03:10 AM #1
    fc911c
    fc911c is offline Registered
    Join Date
    May 2005
    Posts
    39

    Angular Bearings in a RF 45

    Has anyone installed these in a RF45? On page 1052 in McMaster Carr has some I was thinking about getting. This is the second set of tapered bearings I put in, they just don't hold up with higher RPM, both will run around $110.00.

    Thanks
    Frak
    Reply With Quote Reply With Quote
  2. 01-14-2007, 11:59 PM #2
    fc911c
    fc911c is offline Registered
    Join Date
    May 2005
    Posts
    39
    Anybody???

    Thanks
    Frank
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules