I bought an old DynaCNC table with a Dyna1000-THC controller (didn't know they were defunct) and was just getting it kind of figured out, when the 10 year old computer decided to fry itself.
I did what any newbie would have done and bought a new computer. Now for my problems....
Mach 3 won't run on 64 bit, so I bought Mach4.....Apparently Mach doesn't really like to pay anyone to offer tech support to its customers. It appears that I need some sort of plugin and need to setup the software to run the control box.
Have any of you been through this and can lead me to a manual that will give me some direction. I am very green with this stuff.
I am about $10,000 into this adventure so far, I am frustrated to say the least.:drowning: