[visky]

I have got few servo motors :
AEG G15 12N
Mot.Nr. 109 249
U=110Volt I=8,3Amp P=0,73kW max.1700 u/min
They are with Tachometer-dynamo
Typ TDP 0,09-3
40Volt 10mAmp max.40mAmp
1000 u/min and max. 9000 u/min
VDE 0530 IP44

GETTYS B.V.-IRISH BRANCH
Dublin,Ireland
Permanent magnet field servo motor
Type :16-0071-34
data sheet:201-113-1004
connection dia.201-133-1038

Could you help me find drivers and all other devices that i could full control them by PC with software like TurboCNC ,Mach 3 etc?
I must say that these are servors all on old NC machines and i have plan rebuilt it to CNC and have full control by PC softwer:
-2,3,4 axes servo motors
-spindle
-tool change
-wather on /off

[Al_The_Man]

You won't need the Tachometers for modern drives using torque mode of operation.
If you are going with PC/parallel port system then you will need step/direction drives capable of the max Votage/current ratings.
Check the brushes before putting them into operation.
Al.

[faststeve]

Are they DC servo motors. Check out drives from Rutex or Viper drive. I've tried Gecko, with not a lot of luck.