[Gallchobhair]

This is the PP I have been using. Is there a better one to use with UCCNC. Mach2_3_ATC_Arcs_inch.pp.
I also have this I can use Mach3_2010_inch.pp this one seems to have arcs in it.
If there is a better one where can I d/l it. I use VcarvePro8.

Thank You
Don

[silverdog]

Well ... do you have an auto tool change spimdle ? the ATC means AtoToolChange ... if not use the Mach2_3_Arcs_inch.pp.

[Gallchobhair]

I use the auto because I can save my TP's in 1 file. When it comes to a tool change UCCNC stops. I change the tool and
reset Z=0 push run button and the process proceeds.It was working like that in Mach3 and it works in UCCNC. I will be
setting up the auto Z= 0 routine soon. That way I only have to do 1 auto Z and then change bits and UCCNC will probe after
each tool change. Thank you for your input .

Thank you
Don