Re: Jerky Small Straight Line Moves
simplest solution is to buy a cam software that will put out arc moves rather than short line segments . Gutting out a fanuc control to add an inferior product like mach would be foolish in my opinion .
Most modern controls will have have a hard time with short line segments . High speed machining options can run these types of programs smoother and much better , but even then they may not necessarily run these programs at top feed rate if the feed rates are quite high , and this I've seen many times .
The problem isn't the machine , it's the code
A poet knows no boundary yet he is bound to the boundaries of ones own mind !! ........