well i just got the lathe i am using mastercam9 and i can not get the
lathe to receive anything or send.
here is a list of problems
1. looks like it is in metric but i used autocad and it was inch
2. using a null modem cable (sends and receives from my dyna220 mill
just fine)
3.tried using to send,hyperterm. ,mastercam ,ncfree link none worked i
set them all up the same using a sheet from a guy on the cnc zone
4.using the mastercam9 post and did the mods needed to make it work as
per the cnc zone
5.there is a switch on the rs-232 port cable inside the machine going
to the board itself,not sure what that does but i tried it in both
positions still nothing

the null modem cable is a 25 pin on the machine side and 9 pin on the laptop side it works fine with my dyna220 mill

thanks if anyone can help me
joe