Re: Stepperworld FET 4 problem
I made the mistake of buying the exact same setup many years ago and I think that your going to be disappointed in it's performance IF it is even possible to get those tiny motors to move your mill .
I had the same determination with using that board and to get more out of it. I eventually bought bigger motors , went thru all the crap of fitting resistors , and after a short period I cut my losses and bought better drivers (gecko) .
Those motors are very weak and they are extremely slow . IF you can move the axis with them then it'll be so slow that the mill won't be of much use anyhow
.
I wish that I could help to get it running , but it's sooooo far gone from my memory on the wiring and such , and I have no more documentation . Best thing I can do at this point is give you the same advice that I refused to listen to and that is to spend the money again and start with a better setup , because it won't be long before you'll find yourself doing it anyhow
A poet knows no boundary yet he is bound to the boundaries of ones own mind !! ........