Hi
I would kindly ask if anyone can help me. Sheetcam for plasma make inside edge round instead of sharp corner and I am wondering if I am doing something wrong?
Here is the picture of my problem
Thanks for all your help
Hi
I would kindly ask if anyone can help me. Sheetcam for plasma make inside edge round instead of sharp corner and I am wondering if I am doing something wrong?
Here is the picture of my problem
Thanks for all your help
Since you are plasma cutting you will not get sharp corners, especially on an "inside" one. "Outside" corners can be improved to be reasonable by doing a loop so that the plasma cut crosses over itself. Are you using torch height control? What kind, arc voltage or some kind of foot sensor?