I just got this lathe and am unsure what to purchase to power the required 200v 3 phase. I have a rpc that supplied 230 volt 3 phase. Do I need to purchase 3 buck/boost transformers to drop each leg from 230 to 200? Thanks, Chris.
Thread: Powering 1992 Citizen L-16
Results 1 to 3 of 3
-
05-15-2016, 01:06 AM #1
Registered
- Join Date
- May 2010
- Posts
- 54
Powering 1992 Citizen L-16
-
05-18-2016, 10:34 AM #2
Registered
- Join Date
- May 2010
- Posts
- 54
Re: Powering 1992 Citizen L-16
Ok, so I need 2 240/120 16/32 1kv buck boost transformers, They get installed between the 220 single phase panel and the rpc.
-
05-27-2016, 10:19 PM #3
Registered
- Join Date
- May 2010
- Posts
- 54
Re: Powering 1992 Citizen L-16
Correction to my earlier post. I will be wiring lathe in an open delta configuration after the rpc.
Reply With QuoteSimilar Threads
-
1992 VF2 Wieght
By dafowfidy in forum Haas MillsReplies: 4Last Post: 02-13-2022, 02:03 PM -
NEWBIE to Citizen - G32 thread whirling on Citizen L520???
By jmonty in forum CNC Swiss Screw MachinesReplies: 1Last Post: 09-07-2013, 06:50 PM -
Looking for Parts 1992 Citizen L20
By RussellSt in forum CNC Swiss Screw MachinesReplies: 5Last Post: 08-21-2013, 09:32 PM -
1992 VF2 Inconsistant X
By dafowfidy in forum Haas MillsReplies: 1Last Post: 03-31-2009, 03:21 AM -
Fanuc OT-C Not Powering Up
By JerryH in forum FanucReplies: 4Last Post: 08-22-2007, 12:34 PM
Tags for this Thread
Posting Permissions
