[aldepoalo]

Does anyone know how to peck tap on a HAAS?

[Louis_Cannell]

No but this might be worth a look

http://www.cnczone.com/forums/genera...d-tapping.html

[djr76]

Make sure you have rigid tapping parameter turned on. forget which one though, consult manual.

1/4-20 example

G43 G00 Z.2
S200 M5
G84 G98 Z-.1 R.2 F10.
G84 G98 Z-.2 R.2 F10.
G84 G98 Z-.3 R.2 F10.
G80
G00 (Next hole location)

[beege]

Make sure you have rigid tapping parameter turned on. forget which one though, consult manual.

1/4-20 example

G43 G00 Z.2
S200 M5
G84 G98 Z-.1 R.2 F10.
G84 G98 Z-.2 R.2 F10.
G84 G98 Z-.3 R.2 F10.
G80
G00 (Next hole location)

I don't think you need all that repetition, as the parameters are modal.

G43 G00 Z.2
S200 M5
G84 G98 Z-.1 R.2 F10.
Z-.2
Z-.3
G80
G00 (Next hole location)

Should work, too.

[extanker59]

Yup, Beege is right. That's how we do it when we peck tap. Works fine.

[ksanalytical]

Haas just put out video on this.

https://www.youtube.com/watch?v=yBK1MN_Q9J0

[HelicopterJohn]

Hi,

I use ONECNCXR5 Mill Professional.

It has pecking tapping already built into the software.

Just pick either 2 level or 3 level peck tapping and fill in the desired peck depths and presto you have it all done for you automatically. If you look at the right side of the screens you will see where you fill in the desired pecking depths.

John

[allenp]

what a stupid way to peck tap, on fanuc you just add Q3 for example, it'll do same thing as in drilling cycle.
why can't it be done that way on haas in g84?

[cygnus x-1]

what a stupid way to peck tap, on fanuc you just add Q3 for example, it'll do same thing as in drilling cycle.
why can't it be done that way on haas in g84?

That's a good question. The Haas method seems a bit tedious.


C|