I`m trying to use the turbocnc program, i boot in dos, when i run the executable i get the message co-mathematic processor not found??
Anyone have an idea on this?
Thanks,
Alex
I`m trying to use the turbocnc program, i boot in dos, when i run the executable i get the message co-mathematic processor not found??
Anyone have an idea on this?
Thanks,
Alex
Are you using a 386 processor? You need a 486DX or better.
Gerry
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I`m using Athlon XP2000.
Does i need a really old computer ro run this program??
Hmmm...that is a good one...you may want to let Dave know. www.dakeng.com
E
I wish it wouldn't crash.
I had this very same issue with turbocnc using a 486DX running 100 megahertz. Plenty machine to run turbocnc. Same error message using my new laptop. Contacted Dave. He responded that his computer gave him the very same message.
I gathered that the solution is to ignore the message and move on.
Mike