When plasma cutting galvanized steel, the edge of the cut will rust now right?
What can be done to prevent this?
When plasma cutting galvanized steel, the edge of the cut will rust now right?
What can be done to prevent this?
http://www.htpweld.com/products/accessories/a6.html
prime-a-weld is great stuff.
Home depot also sells a Zinc primer that works real good.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
"If the women don't find you handsome, they should at least find you handy"
-RedGreen show.