[jayratio]

Hello Team,

We have an Amada Pega 345 with Fanuc 04PC Controller, we lost its parameters and are now unable to get from anywhere.

Need Help Urgently. If somebody has parameters for this machine/controller.

Regards,

Ajay

[lycarem11]

Hello Team,

We have an Amada Pega 345 with Fanuc 04PC Controller, we lost its parameters and are now unable to get from anywhere.

Need Help Urgently. If somebody has parameters for this machine/controller.

Regards,

Ajay

Where are you? If you still need parameter, it's here : https://www.dropbox.com/sh/jy6a0lkzmxmvsr7/AADG-FObexp3H6PkXSTymgw8a?dl=0

[arsh69]

Where are you? If you still need parameter, it's here : https://www.dropbox.com/sh/jy6a0lkzm...XSTymgw8a?dl=0

hi, i have the same problem, can you help me?the above link not working,please help,i need Diagnostic parameters for Amada Pega 345 Fanuc 04pc

[AMADAJOE]

hi, i have the same problem, can you help me?the above link not working,please help,i need Diagnostic parameters for Amada Pega 345 Fanuc 04pc

Email me I will send you file. What turret config do you have 58 station 2 AI?
Regards,
[email protected]

[PHDuc]

Where are you? If you still need parameter, it's here : https://www.dropbox.com/sh/jy6a0lkzm...XSTymgw8a?dl=0

dear, do you have 04PC parameter for VIPROS 358Q, i have arlarm 417 727,

please help

[jomarmilo]

Hi,

Can you please help me on how to get to PMC parameters in Fanuc 04PC? I need to check the timer parameters on PMC.
Machine is VIPROS 357.

Thank you very much

[AMADAJOE]

MDI mode, Press FUNC & ALARM key, select Diagnosis at bottom of screen. They are under that screen