Re: VAC Unit for Okuma Cadet CNC
We did find that the fan is not working, finally found one online...
hello, as okumawiz just said, i was going to suggest you a step-by-step approach ... actually, i would suggest to plug in your machine you know, like to check simpler and obvious things 1st
about that fan, also verify if it receives power ... if yes, than it is broken ... if not, than is something else
make a heat diagram on your motor ... hope there is no problem inside
also, about fan replacing ... if it runs faster when motor gets hotter, than replacing it may solve things temporaly ... if it always spins at same rpm, just replace it
compare heat diagram with one from a similar engine
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg