[rirazvan]

Hello

I started retrofitting this machine assembled in 1989 in UK and encountered trouble with the rewiring.
The machine came without the electrical diagram.

I did remove from the machine FC335M NC controller.
X, Y, Z axis driver MR-S1, MR-S11 and servo motors.
The parts removed are useless to me if anyone needs them let me know maybe we can trade something for the electrical manual.

I installed:
MR-J2S 750W servos instead of the old HA-83C .
Mesa 7I77 card with 5I25.

I need the wire map of INPUT and OUTPUT from the board BB21A, BN624A942H01.

Can I get some help with the BB21A pins/connectors?

Thanks

Razvan

[EliseoMonteverd]

Is yours Mazatrol M32?

[rirazvan]

Hello,

Our NC was a M32. We did remove it and we use one PC with LinuxCNC.

Razvan

[EliseoMonteverd]

Ok, I have the same machine, I will try to help you. I am a machinist, not a electrician. Please, confirm the picture, if it is your board.Attachment 323110

[rirazvan]

Ok, I have the same machine, I will try to help you. I am a machinist, not a electrician. Please, confirm the picture, if it is your board.Attachment 323110

Thank you for the answer.

The board in your drawing is the same with the one on my machine..

I need the pins/wires that are connected to that board to connect them to the Mesa 7i77 board.

We did replace the Mazatrol M32 because we got a parity error. I did exchange all the boards on NC controller and did not found the problem.

Attachment 323112

Thank you,
Razvan

[rirazvan]

Retrofit progress:
Here is the machine cabinet with exchanged servo drivers and NC.
I did prepare the machine for five axis. I did install one Granite Argon servo driver capable of driving old HA83C servos for testing only. I will replace it with MR-J2S-70A later on.
Attachment 323114
And the naked machine after a lot of cleaning and cleaning. It was extremely hard to remove the dried deposits of oil and coolant.
Attachment 323116

Razvan

[EliseoMonteverd]

Very good job! Congrats.
I also had problems with the control.
Send me your e-mail, so I will send you some electric manual pictures.
Sorry, I do not have enough time to take pictures to the hole manual, so I wiil try to help you, as much I can.

[eleazarlozano]

help me me podrían pasar el diagrama VQC15/40 ELEMENTARY DIAGRAM BN065C043 F01-1

[EliseoMonteverd]

Eleazar, creo que puedo ayudarte. Me pasas tu email o whatsaap por mensaje privado ?

Enviado desde mi GT-I9500 mediante Tapatalk

[Ishtiaq_Ahmad]

Very good job! Congrats.
I also had problems with the control.
Send me your e-mail, so I will send you some electric manual pictures.
Sorry, I do not have enough time to take pictures to the hole manual, so I wiil try to help you, as much I can.

hello
could you please send me this manual??

[kemppainen]

Hi,

Did you get electrical pictures from somewhere? If you got it, could you send me a copy? I need to find the machine i / o ports. mail: [email protected]

Best Regards,
Tuure Kemppainen

[m0rph0genx6]

And so whats results?

[m0rph0genx6]

I buying also vqc 15,and i also want change controller,else my trasformator is broken..

[fabiomazak]

Good morning, could you also send the electrical manual, thanks
[email protected]

[fabiomazak]

Good morning, could you also send the electrical manual, thanks
[email protected]